SWED/CUT® by Swedev


User Guide


Please contact us or one of our distributors for any information you may need, regarding installation and printer settings.

Guide



 

Recommended settings


  • Check blade holder for any damages and make sure holder is clean inside.
  • Set the blade straight in holder. Check so there is no waviness in blade.
  • When bolts/screws are used for tightening of blade holder, tighten from center and out crosswise.
  • Use as low blade pressure as possible.

Guide


Back-up blade

Back-up blade


The top of the 45˚ back-up blade cut must not reach the end-point of the cylinder when the doctor blade oscillates. It should stop approximately 10 mm from the cylinder end. Only the doctor blade should pass over this area.

Swedcut

We stand for high quality

The SWED/CUT® brand stands for high quality, continuous development, technical support and delivery on time.